How do I scale multiper layers simultaniously?

robert.hiester · Post by **robert.hiester** » Tue Jul 17, 2007 5:45 am

How do I scale multiper layers simultaneously? So that the layers stay proportional to each other. It is possible right? Or is there a workaround if not?

Thank you.

heyvern · Post by **heyvern** » Tue Jul 17, 2007 5:49 am

You could copy/paste the scale values for each layer using the scale layer tool.

Or you could put the layers in a group layer (group or bone layer) and scale the group layer.

The drawback to that is if you move a layer out of the group layer it will revert back to its original "non-scaled" value.

-vern

Post by **Víctor Paredes** » Tue Jul 17, 2007 5:50 am

you can create a new group layer and put all the other layers inside of this. then scale the group layer (this can be a bone layer too).

robert.hiester · Post by **robert.hiester** » Tue Jul 17, 2007 6:02 am

Thank you both. Vern you are a terrific resource. Thanks.

Post by **Víctor Paredes** » Tue Jul 17, 2007 6:05 am

ouch. vern wrote meanwhile i was writing too.