Page 1 of 1

Bind Layer Issues

Posted: Fri Jul 03, 2009 9:27 pm
by Blue
I bound a group layer to a bone in a skeleton, but the bone doesn't seem to have the correct influence on the group layer. The group layer doesn't perfectly mimic what the bone is doing. It's not a bug, just my noob failings. Check it out here:

http://www.joelcardinal.com/tmp/skeltest2.zip

Posted: Fri Jul 03, 2009 10:21 pm
by Mikdog
Ok, easy peezy.

Go to FRAME 0.

Select the head group layer. (BigHead)

Click on the icon in the lower left of the BONES toolbox - that's the bone in front of the piece of paper.

Now click on the head bone.

BAM. You've just properly bound a GROUP layer to the bone.

Oh crap!

Posted: Fri Jul 03, 2009 11:01 pm
by Blue
Who's the man? Mikes the man!

I thought I had done it right but apparently not, I think I was doing things in the opposite order. I thought I was following the procedure in the manual...Anyway works!

BTW, Goldfish is fing amazing!

Posted: Sat Jul 04, 2009 9:50 am
by slowtiger
I thought I was following the procedure in the manual
Yes, that's confusing: layer binging has to be done in a different order of steps than point/region binding.