Page 1 of 1
Move and/or duplicate multiple layers in Debut 5?
Posted: Sat Jan 21, 2012 8:46 pm
by YoungApprentice
Hi, all! I finally got my elbow joints to work like a charm, and it took a LOT of time and tweaking. It would save me upwards of two hours of work if someone could tell me a good way for me to duplicate and move the several vector layers that make up my arm joints all at once. I would also like to know if there is a way to duplicate bones...
Thanks!- YA
Posted: Sat Jan 21, 2012 11:52 pm
by slowtiger
This ability to move more than one layer was introduced in v6.
Posted: Sun Jan 22, 2012 6:32 am
by YoungApprentice
This saddens me greatly.
:'(
I can upgrade to Debut 8 for $15, but I have no idea if it supports these features...(?)
Posted: Sun Jan 22, 2012 3:21 pm
by jahnocli
Can't you just put them in a Group Layer? (Use a Bone Layer instead in Debut).
Posted: Sun Jan 22, 2012 4:55 pm
by slowtiger
No, this is a workflow issue - you just can't select and move/duplicate more than 1 layer in v5.
Posted: Sun Jan 22, 2012 6:03 pm
by YoungApprentice
Yes, I already tried doing the bone layer trick. Does not work D: