Moho Forum

Taking a short break from things that flap to work on things that pop.

Done with switch layers set on step interpolation.

The pops look very good, but where did the pin go? After the first pop it kinda vanished.

Ah, yes, eventually that shape will be the horn of a triceratops.

For the 1st balloon I wanted it in there, since I was having trouble envisioning where the horn would strike the balloon, then I realized as long as the pops look convincing, I could have the ballon be struck practically anywhere and would only have to adjust a few switch layers on each balloon depending on where the horn hit.

Next up is to make it look like a triceratops is popping them.

UPDATE:
----------------------------------------------------

Ok, Danimal, here ya go.








----------------------------------------------------

Looks great! You didn't have to go through all that trouble just for little ol' me though...

Heh. I made every noob mistake there is, no doubt. But once you get used to the software, being able to finally add little touches like that starts to make it fun to use.

Also, needs more Triceratops.