Page 1 of 1
Line jumps slightly from the desired point
Posted: Thu Jun 17, 2021 4:33 pm
by Eric Jacques
Hello all. I am new here (I worked on Anime Studio Pro and now new on Moho) and I have a question. For example, when I move the eyes on the Smart Bones, the eye always jumps slightly from the desired point (as if she had a magnetic floor grid). Does anyone know what this could be due to. (Moho 13.5 / iMac 2019) Thank you
Re: Line jumps slightly from the desired point
Posted: Thu Jun 17, 2021 4:58 pm
by hayasidist
do you have grid / snap to grid enabled?
Re: Line jumps slightly from the desired point
Posted: Fri Jun 18, 2021 4:48 pm
by Eric Jacques
hayasidist wrote: ↑Thu Jun 17, 2021 4:58 pm
do you have grid / snap to grid enabled?
No, the grid or magnetic grid is not activated.
I'll just try again. I have deleted all the smart bones.
Re: Line jumps slightly from the desired point
Posted: Fri Jun 18, 2021 5:34 pm
by Víctor Paredes
The length of a Smart Bone action is also the 'resolution' of the animation a smart bone can trigger.
If your smart bone action doesn't have enough frames, then things can jump from one position to other during the animation.
If it's the case, I recommend you to extend the duration of the Smart Bones actions to at least 100 frames. That should be enough for subtle movement.
Re: Line jumps slightly from the desired point
Posted: Wed Jun 23, 2021 4:41 pm
by Eric Jacques
Hello Victor
Thanks for the good tip. The problem is still there. I will do some tests. Maybe I will recognise the problem. A little fan of "Tasse triste"
Re: Line jumps slightly from the desired point
Posted: Wed Jun 23, 2021 5:53 pm
by synthsin75
Maybe you accidentally keyframed the eyes in another smart bone action?
Re: Line jumps slightly from the desired point
Posted: Fri Jun 25, 2021 2:56 pm
by Eric Jacques
Thank you for the answer. It worked after a few tests. I can only assume that the smart bones had a wrong influence. I redrew the head and the smart bones and finally it worked.