Easier Line Width & Scale Compensation Control
Posted: Thu Aug 05, 2021 1:11 pm
For better, easier and more flexible line/stroke width control of final rigs, I'd like to se the following improvements:
1) It would be nice if you could toggle scale compensation in one click for all layers contained inside a folder/bone layer/switch layer without having to check the box on EVERY. SINGLE. LAYER. IN. A. RIG if you want to switch it on or off for a whole rig.
2) There should be a way to easily increase/decrease line width for all contained layers ad hoc – basically the same that the free Adjust Line Width Script does:
http://mohoscripts.com/script/sz_adjust_line_width
This should be part of normal Moho functionality.
3) "Normalize Layer Scale" should also be applied to all layers contained in a folder/switch layer/bone layer and not just ignored if you apply to these non vector layers.
1) It would be nice if you could toggle scale compensation in one click for all layers contained inside a folder/bone layer/switch layer without having to check the box on EVERY. SINGLE. LAYER. IN. A. RIG if you want to switch it on or off for a whole rig.
2) There should be a way to easily increase/decrease line width for all contained layers ad hoc – basically the same that the free Adjust Line Width Script does:
http://mohoscripts.com/script/sz_adjust_line_width
This should be part of normal Moho functionality.
3) "Normalize Layer Scale" should also be applied to all layers contained in a folder/switch layer/bone layer and not just ignored if you apply to these non vector layers.