Page 1 of 1

bones problem

Posted: Thu Apr 12, 2007 2:50 pm
by toonertime
here is my problem:
I make an image, create a bone layer
then select the image layer and put
it into the bone layer

The problem is when I click the bone
layer to apply bones,
the image I have created isn't
visible in the bone layer to
see where to put the bones

what am i doing wrong?

Posted: Thu Apr 12, 2007 6:09 pm
by Gnaws
does your vector layer have any fills?

Posted: Thu Apr 12, 2007 9:22 pm
by Genete
Be sure that the image or vector layer is visible in edition mode (the two eyes on the left are visible)
Please post a screeeshot of your window layer to see what happen.
Best
Genete

makin bones

Posted: Fri Apr 13, 2007 12:34 am
by toonertime
thanks i will analyze this further and get back to you

what is a good way to capture a screen shot?

Re: makin bones

Posted: Fri Apr 13, 2007 1:23 am
by Touched
toonertime wrote:what is a good way to capture a screen shot?
If you're using Windows, press the Print Screen/PrtScr button, which copies the screen to the clipboard, then paste it into a new document in a paint program. There's a different way to do it on a Mac, which I think is easier.