Point Select tool Issue

Yosemite Sam · Post by **Yosemite Sam** » Sun Nov 24, 2019 10:15 pm

Hey guys, I've finally switched over to Moho 13 permanently. I noticed the points select tool default has changed. I now have to hold control to get the lasso function. Does anyone know how to reverse this? I use the lasso about 99% of the time, so this is quite frustrating. I looked through preferences, but couldn't find a solution there. Thanks!

synthsin75 · Post by **synthsin75** » Mon Nov 25, 2019 3:30 am

There's a lasso checkbox in the tool options, and control temporarily toggles to the opposite of that setting. The new install is likely set to the default.

Yosemite Sam · Post by **Yosemite Sam** » Mon Nov 25, 2019 3:39 am

synthsin75 wrote: ↑Mon Nov 25, 2019 3:30 am There's a lasso checkbox in the tool options, and control temporarily toggles to the opposite of that setting. The new install is likely set to the default.

how did I miss that... thanks again Wes.

synthsin75 · Post by **synthsin75** » Mon Nov 25, 2019 4:45 am

Glad I could help.

Point Select tool Issue

Point Select tool Issue

Re: Point Select tool Issue

Re: Point Select tool Issue

Re: Point Select tool Issue