Adjusting the starting point of a smartbone

[MrMiracle77]

I have a figure with a 180 degree smartbone that transitions it from shape A to shape B to shape C. I did it this way because shape A needs to be very symmetric. However, the default starting pose of the figure is better suited to shape B. Is there a way to change the default starting position of the smartbone?

[Daxel]

Yes you only need to use the transform bone tool at frame 0 to change its starting position. When you have the bone selected and you pick the transform bone tool, you can take a look at the number that appears as the angle of the bone (up, on the tool settings bar) and write the angle you desire there to be precise.

[MrMiracle77]

I'll try that out when I get home. Thank you.