2D master Rigger

Want to hire an Moho animator? Post your job listing here.

Moderators: Víctor Paredes, Belgarath, slowtiger

Post Reply
bcabral23
Posts: 1
Joined: Wed Nov 11, 2026 9:33 am

2D master Rigger

Post by bcabral23 »

I'm building a 2D office comedy and I need ONE master cutout rig in Moho 14 Pro, built to a documented spec so the remaining four characters can be duplicated from it.

Art is done: 5-view turnaround, 41 split PNGs with fixed names, colour palette, bone pivot table. You rig; you don't draw.

Deliverables:
- .moho opening clean on a machine that has never seen the assets
- 16 bones named to my convention (Root>Pelvis>Spine>Chest>Neck>Head, limbs .L/.R)
- Bind Layer on 100% of image layers
- Mouth Switch, 6 states, wired for lip sync from audio
- Smart bone dials: head turn (front to 3/4 to side) + torso lean, no distortion
- Saved actions: IDLE, WALK, TALK, SEATED_IDLE
- 10s test render, 1920x1080, 24fps
- 5-10 min screen recording of hierarchy, dials, actions
- 1-2 pages of written notes

Test before hire: $50-100, rig one arm (shoulder, upper arm, forearm, hand, one elbow dial, sleeve must not tear). Send the .moho plus a 5s render.

Not buying AE/Duik, Spine, Harmony or Blender rigs. No working .moho, no job.

Staging note: show is 3/4-dominant and seated-at-desk. No 360 cycles. An over-built five-view rig is a red flag.

Full spec PDF attached - read it before quoting.
gwhitaker62
Posts: 9
Joined: Thu Oct 22, 2026 9:50 pm

Re: 2D master Rigger

Post by gwhitaker62 »

bcabral23 wrote:Test before hire: $50-100, rig one arm (shoulder, upper arm, forearm, hand, one elbow dial, sleeve must not tear).
bcabral23, fair enough on the test task mate, keeps the time-wasters out. I had a similar brief once for a garage training video, bloke rigged the whole 360 turnaround nobody asked for and the sleeve tore on the first elbow bend anyway... took him three goes to sort the smart bone dial.

Reckon your arm test is the right call, seen too many "finished" rigs that look lovely stood still and fall apart the second you pose them seated at a desk. Good luck with it, hope you get someone who actually reads the spec PDF 🙄
Post Reply