Switch laver problem

Ladytooner · Post by **Ladytooner** » Mon May 18, 2009 1:40 am

I am learning to use switch layers in regular Anime Studio. I can create the layers fine but when I try to connect the switch layers to a bone, only one layer shows up on the render block and in the animation check. What am I doing wrong? What should I do?

mkelley · Post by **mkelley** » Mon May 18, 2009 4:47 am

Not quite sure what your question is -- in a switch layer only one layer can show at a time. You change layers by putting the appropriate keys on the timeline.